[PATCH v2 4/4] arm64: dts: rockchip: use cs-gpios for cros_ec_spi

Brian Norris briannorris at chromium.org
Mon Jun 19 17:47:40 PDT 2017


Hi Mark,

Forgot to follow up here:

On Tue, Jun 13, 2017 at 07:22:25PM +0100, Mark Brown wrote:
> On Tue, Jun 13, 2017 at 10:50:44AM -0700, Brian Norris wrote:
> > On Tue, Jun 13, 2017 at 01:25:43PM +0800, Jeffy Chen wrote:
> > > The cros_ec requires CS line to be active after last message. But the CS
> > > would be toggled when powering off/on rockchip spi, which breaks ec xfer.
> > > Use GPIO CS to prevent that.
> 
> > I suppose this change is fine. (At least, I don't have a good reason not
> > to do this.)
> 
> > But I still wonder whether this is something that the SPI core can be
> > expected to handle. drivers/mfd/cros_ec_spi.c already sets the
> > appropriate trans->cs_change bits, to ensure CS remains active in
> > between certain messages (all under spi_bus_lock()). But you're
> > suggesting that your bus controller may deassert CS if you runtime
> > suspend the device (e.g., in between messages).
> 
> > So, is your controller just peculiar? Or should the SPI core avoid
> > autosuspending the bus controller when it's been instructed to keep CS
> > active? Any thoughts Mark?
> 
> This sounds like the controller being unusual - though frankly the
> ChromeOS chip select usage is also odd so it's fairly rare for something
> like this to come up.  I'd not expect a runtime suspend to loose the pin
> state, though possibly through use of pinctrl rather than the
> controller.

I haven't personally verified this behavior (it probably wouldn't be too
hard to rig up a test driver to hold CS low while allowing the
controller to autosuspend? spidev can do this?), but Rockchip folks seem
to have concluded this.

I suppose I'm fine with relying on cs-gpios as a workaround.

Brian



More information about the linux-arm-kernel mailing list