[PATCH] ARM: dts: omap3-overo: Remove "vqmmc-supply" property from MMC dt node

Ulf Hansson ulf.hansson at linaro.org
Fri Jun 9 03:37:53 PDT 2017


On 9 June 2017 at 10:41, Kishon Vijay Abraham I <kishon at ti.com> wrote:
> commit 94647a30124e2c7 ("ARM: dts: omap3-overo: Enable WiFi/BT combo")
> while enabling WiFi/BT combo added regulator to trigger the nReset
> signal of the Bluetooth module in vqmmc-supply. However BT should be
> handled by UART. Moreover "vqmmc" is not a defined binding for
> omap_hsmmc. While "vqmmc" in mmc2 hasn't caused any issues so far,
> mmc2 will start to mis-behave once omap_hsmmc defines "vqmmc"
> binding.
>
> Remove "vqmmc-supply" property in mmc2 here.
>
> Signed-off-by: Kishon Vijay Abraham I <kishon at ti.com>

Okay, so I assume I also need to carry this in my immutable branch for
the omap driver changes. More precisely before the driver changes?

Wait for Tony to ack this then.

Kind regards
Uffe

> ---
>  arch/arm/boot/dts/omap3-overo-base.dtsi | 11 -----------
>  1 file changed, 11 deletions(-)
>
> diff --git a/arch/arm/boot/dts/omap3-overo-base.dtsi b/arch/arm/boot/dts/omap3-overo-base.dtsi
> index 401fae838fe9..cd220342a805 100644
> --- a/arch/arm/boot/dts/omap3-overo-base.dtsi
> +++ b/arch/arm/boot/dts/omap3-overo-base.dtsi
> @@ -74,16 +74,6 @@
>                 gpio = <&gpio1 16 GPIO_ACTIVE_HIGH>;            /* gpio_16: WiFi nReset */
>                 startup-delay-us = <10000>;
>         };
> -
> -       /* Regulator to trigger the nReset signal of the Bluetooth module */
> -       w3cbw003c_bt_nreset: regulator-w3cbw003c-bt-nreset {
> -               compatible = "regulator-fixed";
> -               regulator-name = "regulator-w3cbw003c-bt-nreset";
> -               regulator-min-microvolt = <3300000>;
> -               regulator-max-microvolt = <3300000>;
> -               gpio = <&gpio6 4 GPIO_ACTIVE_HIGH>;             /* gpio_164: BT nReset */
> -               startup-delay-us = <10000>;
> -       };
>  };
>
>  &omap3_pmx_core {
> @@ -191,7 +181,6 @@
>         pinctrl-names = "default";
>         pinctrl-0 = <&mmc2_pins>;
>         vmmc-supply = <&w3cbw003c_npoweron>;
> -       vqmmc-supply = <&w3cbw003c_bt_nreset>;
>         vmmc_aux-supply = <&w3cbw003c_wifi_nreset>;
>         bus-width = <4>;
>         cap-sdio-irq;
> --
> 2.11.0
>



More information about the linux-arm-kernel mailing list