[PATCH] phy: meson8b-usb2: fix offsets for some of the registers

Jerome Brunet jbrunet at baylibre.com
Fri Feb 10 01:27:54 PST 2017


On Fri, 2017-01-13 at 19:53 +0100, Martin Blumenstingl wrote:
> The register offsets for REG_DBG_UART (and all following) were off by
> 0x4. This was not a problem yet because these registers are currently
> not used by the driver.
> 
> Signed-off-by: Martin Blumenstingl
> <martin.blumenstingl at googlemail.com>

Good catch ! Thx.

Reviewed-by: Jerome Brunet <jbrunet at baylibre.com>

> ---
>  drivers/phy/phy-meson8b-usb2.c | 6 +++---
>  1 file changed, 3 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/phy/phy-meson8b-usb2.c b/drivers/phy/phy-
> meson8b-usb2.c
> index 33c9f4ba157d..30f56a6a411f 100644
> --- a/drivers/phy/phy-meson8b-usb2.c
> +++ b/drivers/phy/phy-meson8b-usb2.c
> @@ -81,9 +81,9 @@
>  	#define REG_ADP_BC_ACA_PIN_GND			BIT(25
> )
>  	#define REG_ADP_BC_ACA_PIN_FLOAT		BIT(26)
>  
> -#define REG_DBG_UART					0x14
> +#define REG_DBG_UART					0x10
>  
> -#define REG_TEST					0x18
> +#define REG_TEST					0x14
>  	#define REG_TEST_DATA_IN_MASK			GENMASK
> (3, 0)
>  	#define REG_TEST_EN_MASK			GENMASK(7,
> 4)
>  	#define REG_TEST_ADDR_MASK			GENMASK(11
> , 8)
> @@ -93,7 +93,7 @@
>  	#define REG_TEST_DATA_OUT_MASK			GENMAS
> K(19, 16)
>  	#define REG_TEST_DISABLE_ID_PULLUP		BIT(20)
>  
> -#define REG_TUNE					0x1c
> +#define REG_TUNE					0x18
>  	#define REG_TUNE_TX_RES_TUNE_MASK		GENMASK(1,
> 0)
>  	#define REG_TUNE_TX_HSXV_TUNE_MASK		GENMASK(3,
> 2)
>  	#define REG_TUNE_TX_VREF_TUNE_MASK		GENMASK(7,
> 4)



More information about the linux-arm-kernel mailing list