[PATCH v3] ARM: da850: Fix LEGO EV3 battery voltage gpio

[David Lechner]

This fixes the battery voltage monitoring gpio-hog settings.

When the gpio is low, it turns off the battery voltage to the ADC chip.
However, this needs to be on all of the time so that we can monitor
battery voltage.

Also, there was a typo that prevented pinmuxing from working correctly.

Signed-off-by: David Lechner <david at lechnology.com>
---

v3 changes:
* Rebased patch so that it applies cleanly to mainline

v2 changes:
* Fixed pinctrl typo

 arch/arm/boot/dts/da850-lego-ev3.dts | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boot/dts/da850-lego-ev3.dts b/arch/arm/boot/dts/da850-lego-ev3.dts
index 413dbd5..81942ae 100644
--- a/arch/arm/boot/dts/da850-lego-ev3.dts
+++ b/arch/arm/boot/dts/da850-lego-ev3.dts
@@ -178,7 +178,7 @@
 	 */
 	battery {
 		pinctrl-names = "default";
-		pintctrl-0 = <&battery_pins>;
+		pinctrl-0 = <&battery_pins>;
 		compatible = "lego,ev3-battery";
 		io-channels = <&adc 4>, <&adc 3>;
 		io-channel-names = "voltage", "current";
@@ -392,7 +392,7 @@
 	batt_volt_en {
 		gpio-hog;
 		gpios = <6 GPIO_ACTIVE_HIGH>;
-		output-low;
+		output-high;
 	};
 };
 
-- 
2.7.4