[PATCH v3 3/4] net: stmmac: register parent MDIO node for sun8i-h3-emac

[Florian Fainelli]

On 08/23/2017 12:49 AM, Maxime Ripard wrote:
> Hi Florian,
> 
> On Tue, Aug 22, 2017 at 11:35:01AM -0700, Florian Fainelli wrote:
>>>>> So I think what you are saying is either impossible or engineering-wise
>>>>> a very stupid design, like using an external MAC with a discrete PHY
>>>>> connected to the internal MAC's MDIO bus, while using the internal MAC
>>>>> with the internal PHY.
>>>>>
>>>>> Now can we please decide on something? We're a week and a half from
>>>>> the 4.13 release. If mdio-mux is wrong, then we could have two mdio
>>>>> nodes (internal-mdio & external-mdio).
>>>>
>>>> I really don't see a need for a mdio-mux in the first place, just have
>>>> one MDIO controller (current state) sub-node which describes the
>>>> built-in STMMAC MDIO controller and declare the internal PHY as a child
>>>> node (along with 'phy-is-integrated'). If a different configuration is
>>>> used, then just put the external PHY as a child node there.
>>>>
>>>> If fixed-link is required, the mdio node becomes unused anyway.
>>>>
>>>> Works for everyone?
>>>
>>> If we put an external PHY with reg=1 as a child of internal MDIO,
>>> il will be merged with internal PHY node and get
>>> phy-is-integrated.
>>
>> Then have the .dtsi file contain just the mdio node, but no internal or
>> external PHY and push all the internal and external PHY node definition
>> (in its entirety) to the per-board DTS file, does not that work?
> 
> If possible, I'd really like to have the internal PHY in the
> DTSI. It's always there in hardware anyway, and duplicating the PHY,
> with its clock, reset line, and whatever info we might need in the
> future in each and every board DTS that uses it will be very error
> prone and we will have the usual bunch of issues that come up with
> duplication.

OK, then what if you put the internal PHY in the DTSI, mark it with a
status = "disabled" property, and have the per-board DTS put a status =
"okay" property along with a "phy-is-integrated" boolean property? Would
that work?

What I really don't think is necessary is:

- duplicating the "mdio" controller node for external vs. internal PHY,
because this is not accurate, there is just one MDIO controller, but
there may be different kinds of MDIO/PHY devices attached

- having the STMMAC driver MDIO probing code having to deal with a
"mdio" sub-node or an "internal-mdio" sub-node because this is confusing
and requiring more driver-level changes that are error prone

Thanks
-- 
Florian