[PATCH] gpio: uniphier: add UniPhier GPIO controller driver

[Linus Walleij]

On Mon, Aug 7, 2017 at 3:50 PM, Masahiro Yamada
<yamada.masahiro at socionext.com> wrote:

> Adding "interrupts" property in DT causes
> of_pupulate_default_populate() to assign virtual IRQ numbers
> before driver probing.  So it does not work well with IRQ domain hierarchy.

I think I heard some noise about this the week before.

> For pinctrl/stm32/pinctrl-stm32.c,
> I do not see "interrupts", so it just straight maps the irq numbers.

I think OMAP and DaVinci does someting similar too. This is from a recent
DaVinci patch from Keerthy:

+Example for 66AK2G:
+
+gpio0: gpio at 2603000 {
+       compatible = "ti,k2g-gpio", "ti,keystone-gpio";
+       reg = <0x02603000 0x100>;
+       gpio-controller;
+       #gpio-cells = <2>;
+       interrupts = <GIC_SPI 432 IRQ_TYPE_EDGE_RISING>,
+                       <GIC_SPI 433 IRQ_TYPE_EDGE_RISING>,
+                       <GIC_SPI 434 IRQ_TYPE_EDGE_RISING>,
+                       <GIC_SPI 435 IRQ_TYPE_EDGE_RISING>,
+                       <GIC_SPI 436 IRQ_TYPE_EDGE_RISING>,
+                       <GIC_SPI 437 IRQ_TYPE_EDGE_RISING>,
+                       <GIC_SPI 438 IRQ_TYPE_EDGE_RISING>,
+                       <GIC_SPI 439 IRQ_TYPE_EDGE_RISING>,
+                       <GIC_SPI 440 IRQ_TYPE_EDGE_RISING>;
+       interrupt-controller;
+       #interrupt-cells = <2>;
+       ti,ngpio = <144>;
+       ti,davinci-gpio-unbanked = <0>;
+       clocks = <&k2g_clks 0x001b 0x0>;
+       clock-names = "gpio";
+};


That looks fairly similar.

Yours,
Linus Walleij