[RESEND PATCH 2/3] ARM: davinci: hawk: Remove vbus and over current gpios

[Sekhar Nori]

On Monday 21 November 2016 10:23 PM, Axel Haslam wrote:
> The hawk board VBUS is fixed to a 5v source, and the over
> current pin is actually not connected to the SoC.
> 
> Do not reseve these gpios for OHCI as they are not related
> to usb.
> 
> Signed-off-by: Axel Haslam <ahaslam at baylibre.com>

As discussed over the MMC/SD patches, this patch should be based off the
hawkboard schematic, not the LCDK schematic.

Thanks,
Sekhar