[PATCH v6 0/7] add NS2 support to bgmac

[David Miller]

From: Jon Mason <jon.mason at broadcom.com>
Date: Fri,  4 Nov 2016 01:10:55 -0400

> Changes in v6:
> * Use a common bgmac_phy_connect_direct (per Rafal Milecki) 
> * Rebased on latest net-next
> * Added Reviewed-by to the relevant patches
> 
> 
> Changes in v5:
> * Change a pr_err to netdev_err (per Scott Branden)
> * Reword the lane swap binding documentation (per Andrew Lunn)
> 
> 
> Changes in v4:
> * Actually send out the lane swap binding doc patch (Per Scott Branden)
> * Remove unused #define (Per Andrew Lunn)
> 
> 
> Changes in v3:
> * Clean-up the bgmac DT binding doc (per Rob Herring)
> * Document the lane swap binding and make it generic (Per Andrew Lunn)
> 
> 
> Changes in v2:
> * Remove the PHY power-on (per Andrew Lunn)
> * Misc PHY clean-ups regarding comments and #defines (per Andrew Lunn)
>   This results on none of the original PHY code from Vikas being
>   present.  So, I'm removing him as an author and giving him
>   "Inspired-by" credit.
> * Move PHY lane swapping to PHY driver (per Andrew Lunn and Florian
>   Fainelli)
> * Remove bgmac sleep (per Florian Fainelli)
> * Re-add bgmac chip reset (per Florian Fainelli and Ray Jui)
> * Rebased on latest net-next
> * Added patch for bcm54xx_auxctl_read, which is used in the BCM54810

Series applied, thanks.