[PATCH v3 6/9] ARM: dts: rockchip: add the sdio power sequence for kylin board

Heiko Stuebner heiko at sntech.de
Sun Jan 17 11:31:01 PST 2016


Am Freitag, 15. Januar 2016, 21:49:53 schrieb Caesar Wang:
> This patch adds the sdio power sequence for kylin board.
> The WLAN attached to a SDIO interface, wifi/bluetooth have
> reset and power been needed to enable.
> 
> AFAIK, the simple power sequence provider sets a value for multiple GPIOs.
> So the reset and power of WlAN chip can be handled in mmc power sequence.
> On the module itself this is one of these, that should can be handled by
> reset GPIOs in simple mmc power sequence.
> 
> The Bluetooth host wake is high active from bootup, this patch is also
> set pinctrl bias as the default to enable the pull up in soc internal.
> 
> Signed-off-by: Caesar Wang <wxt at rock-chips.com>

applied to my dts32 branch for 4.6,

after moving the sdio-pwrseq node to its correct alphabetical position. 
Please try to keep to the sorting :-)


Thanks
Heiko



More information about the linux-arm-kernel mailing list