[PATCH v3 3/3] pci: dra7xx: use pdata callbacks to perform reset

[Kishon Vijay Abraham I]

Hi,

On Wednesday 10 February 2016 07:12 AM, Suman Anna wrote:
> Hi Paul,
> 
> On 02/09/2016 01:36 PM, Paul Walmsley wrote:
>> Hi Suman 
>>
>> On Tue, 9 Feb 2016, Suman Anna wrote:
>>
>>> On 02/09/2016 02:49 AM, Paul Walmsley wrote:
>>>> On Mon, 8 Feb 2016, Suman Anna wrote:
>>>>> On 02/07/2016 08:48 PM, Paul Walmsley wrote:
>>>>>> On Tue, 2 Feb 2016, Kishon Vijay Abraham I wrote:
>>>>>>
>>>>>>> Paul, what do you think is the best way forward to perform reset?
>>>>>>
>>>>>> Many of the IP blocks with PRM hardreset lines are processor IP blocks. 
>>>>>> Those often need special reset handling to ensure that WFI/HLT-like 
>>>>>> instructions are executed after reset.  This special handling ensures that 
>>>>>> the IP blocks' bus initiator interfaces indicate that they are in standby 
>>>>>> to the PRCM - thus allowing power management for the rest of the chip to 
>>>>>> work correctly.
>>>>>>
>>>>>> But that doesn't seem to be the case with PCIe - and maybe others - 
>>>>>> possibly some of the MMUs?  
>>>>>
>>>>> Yeah, the sequencing between clocks and resets would still be the same
>>>>> for MMUs, so, adding the custom flags for MMUs is fine.
>>>>
>>>> I'm curious as to whether HWMOD_CUSTOM_HARDRESET is needed for the MMUs.  
>>>> We've stated that the main point of the custom hardreset code is to handle 
>>>> processors that need to be placed into WFI/HLT, but it doesn't seem like 
>>>> there would be an equivalent for MMUs.  Thoughts?
>>>
>>> The current OMAP IOMMU code already leverages the pdata ops for
>>> performing the resets, so not adding the flags would also require
>>> additional changes in the driver.
>>>
>>> Also, the reset lines controlling the MMUs actually also manage the
>>> reset for all the other sub-modules other than the processor cores
>>> within the sub-systems. We have currently different issues (see [1] for
>>> eg. around the IPU sub-system entering RET in between), so from a PM
>>> point of view, we do prefer to place the MMUs also in reset when we are
>>> runtime suspended.
>>
>> Should we reassert hardreset in _idle() for IP blocks that don't have 
>> HWMOD_CUSTOM_HARDRESET set on them?  Would that allow us to use this 
>> mechanism for the uncore hardreset lines, or are there other quirks?
>>
>> Also - would that address the potential issue that you mentioned with the 
>> PCIe block, or is that a different issue?
> 
> Yeah, I think that would address the PCIe block issue in terms of reset
> state balancing between pm_runtime_get_sync() and pm_runtime_put()
> calls. Right now, they are unbalanced. The PCIe block is using these
> only in probe and remove, so it should work for that IP.

As I mentioned before this would result in undesired behavior during
suspend/resume cycle in PCIe. (This should be okay for the current mainline
code but would break once we add suspend/resume support for PCIe).

Thanks
Kishon