[PATCH] ARM: nomadik: fix up SD/MMC DT settings

[Olof Johansson]

On Mon, Feb 01, 2016 at 02:18:57PM +0100, Linus Walleij wrote:
> The DTSI file for the Nomadik does not properly specify how the
> PL180 levelshifter is connected: the Nomadik actually needs all
> the five st,sig-dir-* flags set to properly control all lines out.
> 
> Further this board supports full power cycling of the card, and
> since this variant has no hardware clock gating, it needs a
> ridiculously low frequency setting to keep up with the ever
> overflowing FIFO.
> 
> The pin configuration set-up is a bit of a mystery, because of
> course these pins are a mix of inputs and outputs. However the
> reference implementation sets all pins to "output" with
> unspecified initial value, so let's do that here as well.
> 
> Cc: stable at vger.kernel.org
> Cc: Ulf Hansson <ulf.hansson at linaro.org>
> Signed-off-by: Linus Walleij <linus.walleij at linaro.org>
> ---
> ARM SoC folks: this fixes the non-working SD/MMC card on the
> Nomadik please apply this directly for fixes if Ulf is OK with
> it.

Thanks, applied.


-Olof