[PATCH 2/2] ARM: at91: at91sam9n12ek/dts: fix the led labels name

Nicolas Ferre nicolas.ferre at atmel.com
Fri Sep 18 06:46:33 PDT 2015


Le 10/09/2015 17:24, Alexandre Belloni a écrit :
> Hi,
> 
> On 10/09/2015 at 17:09:47 +0200, Nicolas Ferre wrote :
>> From: Josh Wu <josh.wu at atmel.com>
>>
>> Correct the led labels in at91sam9n12ek.
>>
>> Signed-off-by: Josh Wu <josh.wu at atmel.com>
>> ---
>>  arch/arm/boot/dts/at91sam9n12ek.dts | 4 ++--
>>  1 file changed, 2 insertions(+), 2 deletions(-)
>>
>> diff --git a/arch/arm/boot/dts/at91sam9n12ek.dts b/arch/arm/boot/dts/at91sam9n12ek.dts
>> index efa75064d38a..186a1705f8d3 100644
>> --- a/arch/arm/boot/dts/at91sam9n12ek.dts
>> +++ b/arch/arm/boot/dts/at91sam9n12ek.dts
>> @@ -204,13 +204,13 @@
>>  		};
>>  
>>  		d9 {
>> -			label = "d6";
>> +			label = "d9";
>>  			gpios = <&pioB 5 GPIO_ACTIVE_LOW>;
>>  			linux,default-trigger = "nand-disk";
>>  		};
>>  
>>  		d10 {
>> -			label = "d7";
>> +			label = "d10";
>>  			gpios = <&pioB 6 GPIO_ACTIVE_HIGH>;
>>  			linux,default-trigger = "heartbeat";
>>  		};
> 
> The only concern being that this renaming will break userspace software
> assuming the LEDs are wrongly named. Is there anything that has been
> released by atmel that uses the wrong names (and my guess is yess and
> that is why there are named as such) and do you care about it?

My guess is that the label was wrongly named from the beginning and no
board revision had the "d6" nor "d7" names.
It makes sense to rename them for the evaluation kit...

Bye,
-- 
Nicolas Ferre



More information about the linux-arm-kernel mailing list