[PATCH 04/11] ARM: DT: STiH407: Add serial3 pinctrl configuration

[Peter Griffin]

Add missing serial 3 pinctrl config. This can be used
on b2206 HVK, where it defaults to PIO31[3] & PIO31[4],
alternate 1.

Signed-off-by: Erwan Le Ray <erwan.leray at st.com>
Signed-off-by: Fabrice Gasnier <fabrice.gasnier at st.com>
Acked-by: Carmelo Amoroso <carmelo.amoroso at st.com>
Acked-by: Patrice Chotard <patrice.chotard at st.com>
Signed-off-by: Patrice Chotard <patrice.chotard at st.com>
Signed-off-by: Peter Griffin <peter.griffin at linaro.org>
---
 arch/arm/boot/dts/stih407-pinctrl.dtsi | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/arch/arm/boot/dts/stih407-pinctrl.dtsi b/arch/arm/boot/dts/stih407-pinctrl.dtsi
index bb3b0c7..6c81f35 100644
--- a/arch/arm/boot/dts/stih407-pinctrl.dtsi
+++ b/arch/arm/boot/dts/stih407-pinctrl.dtsi
@@ -809,6 +809,15 @@
 					};
 				};
 			};
+
+			serial3 {
+				pinctrl_serial3: serial3-0 {
+					st,pins {
+						tx = <&pio31 3 ALT1 OUT>;
+						rx = <&pio31 4 ALT1 IN>;
+					};
+				};
+			};
 		};
 
 		pin-controller-flash {
-- 
1.9.1