[PATCH v2 0/3] ARM: dts: sun4i: Enable USB DRC and voltage-scaling on pcDuino1/2

[Siarhei Siamashka]

Hello,

This is the v2 of the older patches from:
    http://lists.infradead.org/pipermail/linux-arm-kernel/2015-October/374377.html

Changes since v1:
- The voltage scaling patch (AXP209 PMU regulators) has been already
  applied by Maxime, so it is not included in this patch set anymore.
- A new patch with a separate dts for pcDuino2 has been added,
  as had been requested during the previous review round.
- Instead of removing "usb1_vbus-supply" and "usb2_vbus-supply",
  they now refer to "reg_vcc5v0" (this had been discussed on IRC).

Siarhei Siamashka (3):
  ARM: dts: sun4i: Allow to use the PH6 pin for GPIO on pcDuino1/2
  ARM: sun4i: dt: Add new LinkSprite pcDuino2 board
  ARM: dts: sun4i: Enable USB DRC on pcDuino1/2

 arch/arm/boot/dts/Makefile               |  3 +-
 arch/arm/boot/dts/sun4i-a10-pcduino.dts  | 29 ++++++++----
 arch/arm/boot/dts/sun4i-a10-pcduino2.dts | 78 ++++++++++++++++++++++++++++++++
 3 files changed, 100 insertions(+), 10 deletions(-)
 create mode 100644 arch/arm/boot/dts/sun4i-a10-pcduino2.dts

-- 
2.4.9