[PATCH 2/2] arm64: dts: exynos7: Enable HS200 mode operation

[Alim Akhtar]

Hi Krzysztof,

On 11/02/2015 05:28 PM, Krzysztof Kozlowski wrote:
> Subject - name of the board at the end (not the name of the SoC):
> arm64: dts: Enable HS200 mode operation on exynos7-espresso
>
> 2015-11-02 19:04 GMT+09:00 Alim Akhtar <alim.akhtar at samsung.com>:
>> This patch enables HS200 mode operation on exynos7 based
>> espresso board.
>> This also remove _broken-cd_ property as per mmc binding documentation
>
> s/remove/removes/
>
>> which say one of the properties between broken-cd and non-removable
>
> s/say/says/
>
>> should be used. And we already use _non-removable_ as emmc mounted
>> on board which is a non-removable device.
>>
>> Signed-off-by: Alim Akhtar <alim.akhtar at samsung.com>
>> ---
>>   arch/arm64/boot/dts/exynos/exynos7-espresso.dts |    2 +-
>>   1 file changed, 1 insertion(+), 1 deletion(-)
>>
>> diff --git a/arch/arm64/boot/dts/exynos/exynos7-espresso.dts b/arch/arm64/boot/dts/exynos/exynos7-espresso.dts
>> index 8ce04a0ec928..7f19b99fc85b 100644
>> --- a/arch/arm64/boot/dts/exynos/exynos7-espresso.dts
>> +++ b/arch/arm64/boot/dts/exynos/exynos7-espresso.dts
>> @@ -405,8 +405,8 @@
>>   &mmc_0 {
>>          status = "okay";
>>          num-slots = <1>;
>> -       broken-cd;
>>          cap-mmc-highspeed;
>> +       mmc-hs200-1_8v;
>
> The "mmc-ddr-1_8v" should also be supported but I guess you did not
> add it on purpose?
>
Well, I have not tested it, that why didn't added. Will check if this 
works then will add.
Thanks for your comments.

> Best regards,
> Krzysztof
>