[PATCH] ARM: mvebu: GPIO reset on GlobalScale Mirabox

[Gregory CLEMENT]

Hi Leigh,

On 25/03/2015 22:33, Leigh Brown wrote:
> Add support for the system reset button on the GlobalScale Mirabox.
> The reset button is connected via GPIO so add a gpio-keys entry for
> it in the device tree file.  Patch is based on the implementation
> in armada-370-netgear-rn102.dts but using the GPIO pin specified in
> the original patch by Ezequiel Garcia from 2013.
> 

Thanks for your contribution, however the reset button is not always
connected to this GPIO. At least on the Mirabox I have the reset button
triggers an hardware reset. My concern is that for some board the dts
representation would be wrong.

I am not really against this patch, first because it is possible that the
board I got was an exception, but as we don't have any feedback from GlobalScale,
it is hard to figure out. Then, I am not sure that exposing this reset button
when it was not trigger by software was a problem. I have to test it and also
think about it.

I would like to have the opinion of other people about it.


Thanks,

Gregory



> Tested with the triggerhappy daemon.
> 
> Signed-off-by: Leigh Brown <leigh at solinno.co.uk>
> ---
>  arch/arm/boot/dts/armada-370-mirabox.dts | 18 ++++++++++++++++++
>  1 file changed, 18 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/armada-370-mirabox.dts b/arch/arm/boot/dts/armada-370-mirabox.dts
> index e1b0eb6..41f453d 100644
> --- a/arch/arm/boot/dts/armada-370-mirabox.dts
> +++ b/arch/arm/boot/dts/armada-370-mirabox.dts
> @@ -9,6 +9,7 @@
>   */
>  
>  /dts-v1/;
> +#include <dt-bindings/input/input.h>
>  #include <dt-bindings/gpio/gpio.h>
>  #include "armada-370.dtsi"
>  
> @@ -78,6 +79,18 @@
>  				};
>  			};
>  
> +			gpio-keys {
> +				compatible = "gpio-keys";
> +				pinctrl-0 = <&reset_button_pin>;
> +				pinctrl-names = "default";
> +
> +				reset-button {
> +					label = "Reset Button";
> +					linux,code = <KEY_RESTART>;
> +					gpios = <&gpio1 26 GPIO_ACTIVE_LOW>;
> +				};
> +			};
> +
>  			mdio {
>  				pinctrl-0 = <&mdio_pins>;
>  				pinctrl-names = "default";
> @@ -168,5 +181,10 @@
>  		marvell,pins = "mpp64", "mpp65";
>  		marvell,function = "gpio";
>  	};
> +
> +	reset_button_pin: reset-button-pin {
> +		marvell,pins = "mpp58";
> +		marvell,function = "gpio";
> +	};
>  };
>  
> 


-- 
Gregory Clement, Free Electrons
Kernel, drivers, real-time and embedded Linux
development, consulting, training and support.
http://free-electrons.com