[PATCH v3 00/15] Add support to STMicroelectronics STM32 family

[Maxime Coquelin]

From: Maxime Coquelin <mcoquelin.stm32 at gmail.com>

This third round tries to address most of the comments made on previous series.

It contains few less patches, as the reset_controller_of_init() patch has been
removed, now that the bootlaoder handles the reset of the timers.

The pinctrl driver has also been removed after Linus review.
It will be reworked to use the generic pinconf bindings, and may contain
changes for other machines (Mediatek), to add support for pinmux property
handling directly in pinconf-generic.

STM32 MCUs are Cortex-M CPU, used in various applications (consumer
electronics, industrial applications, hobbyists...).
Datasheets, user and programming manuals are publicly available on
STMicroelectronics website.

With this series applied, the STM32F419 Discovery can boot succesfully.


Changes since v2:
-----------------
 - Remove pinctrl driver from the series. 
 - Remove reset_controller_of_init(), and reset the timers in the bootloader
 - Add HW flow contrl property for serial driver
 - Lots of changes in the DTS file, as per Andreas recommendations
 - Some Kconfig clean-ups
 - Adapt the config to be compatible with Andreas' bootwrapper, except UART port.
 - Various fixes in documentation

Changes since v1:
-----------------
 - Move bindings documentation in their own patches (Andreas)
 - Rename ARM System timer to armv7m-systick (Rob)
 - Add clock-frequency property handling in armv7m-systick (Rob)
 - Re-factor the reset controllers into a single controller (Philipp)
 - Add kerneldoc to reset_controller_of_init (Philipp)
 - Add named constants in include/dt-bindings/reset/ (Philipp)
 - Make pinctrl driver to depend on ARCH_STM32 or COMPILE_TEST (Geert)
 - Introduce CPUV7M_NUM_IRQ config flag to indicate the number of interrupts
supported by the MCU, in order to limit memory waste in vectors' table (Uwe)


Maxime Coquelin (15):
  scripts: link-vmlinux: Don't pass page offset to kallsyms if XIP
    Kernel
  ARM: ARMv7-M: Enlarge vector table up to 256 entries
  dt-bindings: Document the ARM System timer bindings
  clocksource: Add ARM System timer driver
  dt-bindings: Document the STM32 reset bindings
  drivers: reset: Add STM32 reset driver
  dt-bindings: Document the STM32 timer bindings
  clockevent: Add STM32 Timer driver
  dt-bindings: Document the STM32 USART bindings
  serial: stm32-usart: Add STM32 USART Driver
  ARM: Add STM32 family machine
  ARM: dts: Add ARM System timer as clockevent in armv7m
  ARM: dts: Introduce STM32F429 MCU
  ARM: configs: Add STM32 defconfig
  MAINTAINERS: Add entry for STM32 MCUs

 Documentation/arm/stm32/overview.txt               |  32 +
 Documentation/arm/stm32/stm32f429-overview.txt     |  22 +
 .../devicetree/bindings/arm/armv7m_systick.txt     |  26 +
 .../devicetree/bindings/reset/st,stm32-rcc.txt     | 102 +++
 .../devicetree/bindings/serial/st,stm32-usart.txt  |  32 +
 .../devicetree/bindings/timer/st,stm32-timer.txt   |  22 +
 MAINTAINERS                                        |   8 +
 arch/arm/Kconfig                                   |  18 +
 arch/arm/Makefile                                  |   1 +
 arch/arm/boot/dts/Makefile                         |   1 +
 arch/arm/boot/dts/armv7-m.dtsi                     |   6 +
 arch/arm/boot/dts/stm32f429-disco.dts              |  71 +++
 arch/arm/boot/dts/stm32f429.dtsi                   | 226 +++++++
 arch/arm/configs/stm32_defconfig                   |  71 +++
 arch/arm/kernel/entry-v7m.S                        |  13 +-
 arch/arm/mach-stm32/Makefile                       |   1 +
 arch/arm/mach-stm32/Makefile.boot                  |   3 +
 arch/arm/mach-stm32/board-dt.c                     |  19 +
 arch/arm/mm/Kconfig                                |  15 +
 drivers/clocksource/Kconfig                        |  15 +
 drivers/clocksource/Makefile                       |   2 +
 drivers/clocksource/armv7m_systick.c               |  78 +++
 drivers/clocksource/timer-stm32.c                  | 184 ++++++
 drivers/reset/Makefile                             |   1 +
 drivers/reset/reset-stm32.c                        | 125 ++++
 drivers/tty/serial/Kconfig                         |  17 +
 drivers/tty/serial/Makefile                        |   1 +
 drivers/tty/serial/stm32-usart.c                   | 695 +++++++++++++++++++++
 include/uapi/linux/serial_core.h                   |   3 +
 scripts/link-vmlinux.sh                            |   2 +-
 30 files changed, 1807 insertions(+), 5 deletions(-)
 create mode 100644 Documentation/arm/stm32/overview.txt
 create mode 100644 Documentation/arm/stm32/stm32f429-overview.txt
 create mode 100644 Documentation/devicetree/bindings/arm/armv7m_systick.txt
 create mode 100644 Documentation/devicetree/bindings/reset/st,stm32-rcc.txt
 create mode 100644 Documentation/devicetree/bindings/serial/st,stm32-usart.txt
 create mode 100644 Documentation/devicetree/bindings/timer/st,stm32-timer.txt
 create mode 100644 arch/arm/boot/dts/stm32f429-disco.dts
 create mode 100644 arch/arm/boot/dts/stm32f429.dtsi
 create mode 100644 arch/arm/configs/stm32_defconfig
 create mode 100644 arch/arm/mach-stm32/Makefile
 create mode 100644 arch/arm/mach-stm32/Makefile.boot
 create mode 100644 arch/arm/mach-stm32/board-dt.c
 create mode 100644 drivers/clocksource/armv7m_systick.c
 create mode 100644 drivers/clocksource/timer-stm32.c
 create mode 100644 drivers/reset/reset-stm32.c
 create mode 100644 drivers/tty/serial/stm32-usart.c

-- 
1.9.1