[PATCH 2/3] arm: dts: phy3250: add SD fixed regulator

[Vladimir Zapolskiy]

On 20.12.2015 01:48, Russell King - ARM Linux wrote:
> On Sun, Dec 20, 2015 at 01:32:11AM +0200, Vladimir Zapolskiy wrote:
>> @@ -162,6 +171,7 @@
>>  				cd-gpios = <&gpio 3 1 0>;
>>  				cd-inverted;
>>  				bus-width = <4>;
>> +				vqmmc-supply = <&sd_reg>;
> 
> This looks wrong.  ios->power_mode controls the _card_ power (which is
> vmmc-supply), not the signalling power (which is vqmmc-supply):

>From drivers/mmc/host/mmci.c mmci_set_ios() manages both regulators,
mmc->supply.vmmc is changed on MMC_POWER_OFF and MMC_POWER_UP,
mmc->supply.vqmmc is changed on MMC_POWER_OFF and MMC_POWER_ON.

But I agree that vmmc-supply is the right choice here, GPIO regulator
controls an SD card power here, thanks for the finding.

> - vmmc-supply            : phandle to the regulator device tree node, mentioned
>                            as the VCC/VDD supply in the eMMC/SD specs.
> 
> - vqmmc-supply           : phandle to the regulator device tree node, mentioned
>                            as the VCCQ/VDD_IO supply in the eMMC/SD specs.
> 
> 

--
With best wishes,
Vladimir