[PATCH v3 5/6] pinctrl: dt-binding: Extend meson documentation with GPIO IRQs support

[Rob Herring]

On Tue, Dec 01, 2015 at 05:24:21PM +0100, Carlo Caione wrote:
> From: Carlo Caione <carlo at endlessm.com>
> 
> Extend the pinctrl binding documentation with the support for external
> GPIO interrupts.
> 
> Signed-off-by: Carlo Caione <carlo at endlessm.com>
> Signed-off-by: Beniamino Galvani <b.galvani at gmail.com>
> ---
>  Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt | 11 +++++++++++
>  1 file changed, 11 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt b/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt
> index 3f6a524..de669ce 100644
> --- a/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt
> +++ b/Documentation/devicetree/bindings/pinctrl/meson,pinctrl.txt
> @@ -3,6 +3,12 @@
>  Required properties for the root node:
>   - compatible: "amlogic,meson8-pinctrl" or "amlogic,meson8b-pinctrl"
>   - reg: address and size of registers controlling irq functionality
> + - reg-names: should be "irq"
> + - interrupt-controller: marks the device node as an interrupt controller
> + - #interrupt-cells: should be 2. The first cell is the GPIO number. The
> +		     second cell is used to specify trigger type.
> + - amlogic,irqs-gpio: specifies the GPIO IRQ numbers on the GIC (GPIO_IRQ#)
> + - interrupt-parent: specifies the parent interrupt controller.
>  
>  === GPIO sub-nodes ===
>  
> @@ -46,7 +52,12 @@ pinctrl-bindings.txt
>  
>  	pinctrl: pinctrl at c1109880 {
>  		compatible = "amlogic,meson8-pinctrl";
> +		reg-names = "irq";
>  		reg = <0xc1109880 0x10>;
> +		interrupt-parent = <&gic>;
> +		amlogic,irqs-gpio = <64 65 66 67 68 69 70 71>;

Can't you just use "interrupts" here?

Rob

> +		interrupt-controller;
> +		#interrupt-cells = <2>;
>  		#address-cells = <1>;
>  		#size-cells = <1>;
>  		ranges;
> -- 
> 2.5.0
>