[PATCH v2 09/12] ARM: dts: apq8064: Add USB OTG support for CM QS-600

[Srinivas Kandagatla]

On 10/04/15 18:26, Stephen Boyd wrote:
> On 04/10/15 05:34, Srinivas Kandagatla wrote:
>> From: Nicolas Dechesne <nicolas.dechesne at linaro.org>
>>
>> This patch adds USB OTG support on USB1 for Compulab QS-600 Board.
>>
>> Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla at linaro.org>
>> [Srinivas Kandagatla: fixed up regulators and status properties]
>> Signed-off-by: Nicolas Dechesne <nicolas.dechesne at linaro.org>
>> ---
>>   arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts | 17 +++++++++++++++++
>>   1 file changed, 17 insertions(+)
>>
>> diff --git a/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts b/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
>> index fc69931..d353694 100644
>> --- a/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
>> +++ b/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
>> @@ -101,6 +101,14 @@
>>   			};
>>   		};
>>
>> +		/* OTG */
>> +		usb1_phy:phy at 12500000 {
>
> Space after that ':' please.
>
Yep, I will fix it in next version.
>> +			status		= "okay";
>> +			vddcx-supply	= <&pm8921_s3>;
>> +			v3p3-supply	= <&pm8921_l3>;
>> +			v1p8-supply	= <&pm8921_l4>;
>> +		};
>> +
>>   		usb3_phy:phy at 12520000 {
>>   			status		= "okay";
>>   			vddcx-supply	= <&pm8921_s3>;
>> @@ -115,6 +123,15 @@
>>   			v1p8-supply	= <&pm8921_l23>;
>>   		};
>>
>> +		gadget1:gadget at 12500000 {
>> +			status = "ok";
>> +		};
>> +
>> +		/* OTG */
>> +		usb1: usb at 12500000 {
>
> This one is good.
>
>> +			status = "ok";
>> +		};
>> +
>>   		usb3: usb at 12520000 {
>>   			status = "okay";
>>   		};
>
>