exynos5420/arndale-octa: imprecise external aborts on exynos_defconfig

[Kevin Hilman]

Thomas Abraham <ta.omasab at gmail.com> writes:

> On Thu, Sep 11, 2014 at 12:16 AM, Kevin Hilman <khilman at kernel.org> wrote:
>> Tyler Baker <tyler.baker at linaro.org> writes:
>>
>>> Exynos5420-based Arndale octa boards have recently started failing boot
>>> tests due to imprecise external aborts.  This only appears to happen
>>> when using exynos_defconfig and boots fine with multi_v7_defconfig.  The
>>> issue seems to be intermittent, so is not reliably reproducable and
>>> difficult to bisect.  Here are a few boot logs from recent
>>> mainline/linux-next kernels that are failing:
>>
>> FYI, I'm seeing the same periodic aborts.  For example, here's my boot
>> of next-20140910:
>> http://images.armcloud.us/kernel-ci/next/next-20140910/arm-exynos_defconfig/boot-exynos5420-arndale-octa.html
>>
>> However, my userspace is much simpler and doesn't seem to cause a panic,
>> so my boot tests report passing. (I should fixup my scripts so these
>> imprecise aborts are reported as a FAIL.)
>>
>> I'm glad you pointed out that it happens only with exynos_defconfig and
>> not multi_v7_defconfig because I noticed that too.  I haven't had the
>> time to track it any further than that, so maybe the exynos folks can
>> help track it down from here.
>>
>> Thanks for reporting this,
>>
>> Kevin
>
> Hi Tyler, Kevin,
>
> From the bootlog you have shared,
>
> [    1.060016] CPU4: failed to come online
> [    2.070031] CPU5: failed to come online
> [    3.080049] CPU6: failed to come online
> [    4.090066] CPU7: failed to come online
> [    4.090099] Brought up 4 CPUs
> [    4.090109] SMP: Total of 4 processors activated.
> [    4.090119] CPU: WARNING: CPU(s) started in wrong/inconsistent
> modes (primary CPU mode 0x13)
> [    4.090128] CPU: This may indicate a broken bootloader or firmware.
>
> Would it be possible to set max cpus to 1, disable switcher and try
> again. I don't have a arndale octa board but I have tested mainline
> kernel with smdk5420 board. It boots all eight CPUs, switcher works
> fine and there are no imprecise aborts seen.

Sorry for the delay, I'm travelling this week.

FWIW, the same CPU boot failures you hilight above are happening on
multi_v7_defconfig[1] which is not getting the imprecise abort.  This is
only happening on exynos_defconfig[2], so I'm curious why you think the
switcher or NR_CPUS might be the issues.

Anyways, I narrowed this down a bit and discovered it's
CONFIG_EXYNOS5420_MCPM=y that's the root cause.  If I use
exynos_defconfig and then disable that option, I don't get any more
imprecise aborts.

Kevin

[1] http://images.armcloud.us/kernel-ci/mainline/v3.17-rc5-25-g8ba4caf/arm-multi_v7_defconfig/boot-exynos5420-arndale-octa.html
[2] http://images.armcloud.us/kernel-ci/mainline/v3.17-rc5-25-g8ba4caf/arm-exynos_defconfig/boot-exynos5420-arndale-octa.html