[PATCH v7 1/2] i2c: imx: add DMA support for freescale i2c driver

[Marek Vasut]

On Wednesday, September 17, 2014 at 04:50:34 PM, Yao Yuan wrote:
[...]
> > > > Would that mean that the "crashed" DMA would be running until the
> > > > next transmission is scheduled ?
> > > 
> > > [Yuan Yao] No, In fact any DMA timeout will result the failure of I2C
> > > transmission and then it will turn to report the exception and wait
> > > for next transmission.
> > 
> > Can you tell when the next transmission will happen? What if I issue a
> > single transmission and that one fails ? Will the DMA run until who knows
> > when ?
> 
> [Yuan Yao]
> Sorry for my unclear description. In fact, During the DMA transmission  if
> an error happened or time out, DMA will stop at once and be disabled.
> I just continue to route the TX and RX request to signal the DMA
> controller. Because the DMA is disabled, it will ignore those signals.
> 
> In a word, I just want to block the I2C TX, RX and interrupt signal when
> DMA mode failed until the next I2C transmission start.

So the I2C block is in error state until you clean it up upon next transmission?

> In fact, the bit "I2CR_DMAEN" is a switch which decide whether I2C route
> the TX, RX and interrupt signal to DMA controller.
> 
> > > The only thing I worried about is I2C may still receive some feedbacks
> > > after DMA timeout. In this case the feedbacks may lead to abnormal
> > > state in PIO mode.But it will be ignored in DMA model.
> > > That's why I tend to delay force-disable DMA until the next
> > > transmission begin. Could you please give me some suggestion?
> > 
> > No, this design just seems flawed to me. You should stop the DMA
> > immediatelly if there is an error to avoid wasting resources and prevent
> > possible other adverse effects.
> 
> [Yuan Yao]
> Yes, I have stopped the DMA immediately. However I keep the I2C DMA
> single route.
> 
> I don't have the exact evidence to prove that my design is acceptable.
> So if you are sure it's flawed, I will change it in the next version(V8).

I'm just trying to understand it.

Best regards,
Marek Vasut