[PATCH] BCM2835: Add I2S driver to device tree

[Stephen Warren]

On 09/17/2014 10:44 AM, Mark Brown wrote:
> On Tue, Sep 16, 2014 at 07:53:09PM -0600, Stephen Warren wrote:
>> On 07/09/2014 02:50 AM, Mark Brown wrote:
>>> From: Mark Brown <broonie at linaro.org>
>
>>> +		bcm2835_i2s: i2s at 7e203000 {
>>> +			compatible = "brcm,bcm2835-i2s";
>>> +			reg = <0x7e203000 0x20>,
>>> +			      <0x7e101098 0x02>;
>>> +
>>> +			dmas = <&dma 2>,
>>> +			       <&dma 3>;
>>> +			dma-names = "tx", "rx";
>>> +		};
>
>> This node is already there (and even edited in this patch), so I dropped
>> that hunk.
>
> Right, not sure what went on with applying it upstream originally but it
> looks like git rebase didn't figure out what was going on well - the
> bcm2835_i2s is needed so we can reference the node.  I'll probably get
> round to resending an incremental patch.

Oh right, I guess I did drop the addition of that label when I dropped 
that node.

The board DT could doesn't necessarily require a label though; it could 
just repeat the node name:

/ {
     i2s at 7e203000 {
         ... extra properties

Still, it looks like we typically use labels to reference nodes in 
bcm2835-*.dts, so adding the label would indeed be a good idea.