[PATCH v2 1/3] ARM: dts: Add Peach Pit dts entry for Atmel touchpad

[Javier Martinez Canillas]

Hello Nick,

On 09/02/2014 03:46 PM, Nick Dyer wrote:
> On 27/08/14 15:22, Javier Martinez Canillas wrote:
>>>> If there was a BTN_NONE or KEY_UNUSED it would had been better but I think
>>>> that making a distinction between these two cases (reserved pin vs GPIO
>>>> available but not used) is useful.
>>>
>>> Maybe Nick can comment here.
> 
> Yes, this is probably useful to document. However, I fear that it's not
> going to be obvious what the distinction is to someone who doesn't have the
> Atmel docs. Perhaps it would be clearer to just do something like:
> 
> 		linux,gpio-keymap = <KEY_RESERVED
> 		                     KEY_RESERVED
> 		                     KEY_RESERVED /* GPIO0 */
> 	        	             KEY_RESERVED /* GPIO1 */
> 		                     KEY_RESERVED /* GPIO2 */
> 		                     BTN_LEFT>;   /* GPIO3 */
> 
> If you omit any trailing KEY_RESERVED values it doesn't affect anything.
> 
> I was also going to suggest that you put something like "/* Atmel mXT224SL
> */" in your .dts file so it's clear what version of the maXTouch device you
> are configuring.
> 

Ok, I'll re-spin with those changes. Thanks a lot for your feedback.

Best regards,
Javier