[PATCH 1/7] ARM: debug: add HiP01 debug uart

[Wang Long]

Add the support of Hisilicon HiP01 debug uart.
The uart of hip01 is 8250 compatible.

Signed-off-by: Wang Long <long.wanglong at huawei.com>
---
 arch/arm/Kconfig.debug | 10 ++++++++++
 1 file changed, 10 insertions(+)

diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug
index d8f6a2e..ab65e58 100644
--- a/arch/arm/Kconfig.debug
+++ b/arch/arm/Kconfig.debug
@@ -240,6 +240,14 @@ choice
 		  Say Y here if you want the debug print routines to direct
 		  their output to the UART on Highbank based devices.
 
+	config DEBUG_HIP01_UART
+		bool "Hisilicon Hip01 Debug UART"
+		depends on ARCH_HIP01
+		select DEBUG_UART_8250
+		help
+		  Say Y here if you want kernel low-level debugging support
+		  on HIP01 UART.
+
 	config DEBUG_HIP04_UART
 		bool "Hisilicon HiP04 Debug UART"
 		depends on ARCH_HIP04
@@ -1117,6 +1125,7 @@ config DEBUG_UART_PHYS
 	default 0x16000000 if ARCH_INTEGRATOR
 	default 0x18000300 if DEBUG_BCM_5301X
 	default 0x1c090000 if DEBUG_VEXPRESS_UART0_RS1
+	default 0x20001000 if DEBUG_HIP01_UART
 	default 0x20060000 if DEBUG_RK29_UART0
 	default 0x20064000 if DEBUG_RK29_UART1 || DEBUG_RK3X_UART2
 	default 0x20068000 if DEBUG_RK29_UART2 || DEBUG_RK3X_UART3
@@ -1240,6 +1249,7 @@ config DEBUG_UART_VIRT
 	default 0xfef36000 if DEBUG_HIGHBANK_UART
 	default 0xfefff700 if ARCH_IOP33X
 	default 0xff003000 if DEBUG_U300_UART
+	default 0xffd01000 if DEBUG_HIP01_UART
 	default DEBUG_UART_PHYS if !MMU
 	depends on DEBUG_LL_UART_8250 || DEBUG_LL_UART_PL01X || \
 		DEBUG_UART_8250 || DEBUG_UART_PL01X || DEBUG_MESON_UARTAO || \
-- 
1.8.3.4