[Patch v5 3/7] mfd: ti-keystone-devctrl: add bindings for device state control

Ivan Khoronzhuk ivan.khoronzhuk at ti.com
Thu May 22 06:48:32 PDT 2014


The Keystone II devices have a set of registers that are used to control
the status of its peripherals. This node is intended to allow access to
this functionality.

Signed-off-by: Ivan Khoronzhuk <ivan.khoronzhuk at ti.com>
---
 .../devicetree/bindings/mfd/ti-keystone-devctrl.txt   | 19 +++++++++++++++++++
 1 file changed, 19 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/mfd/ti-keystone-devctrl.txt

diff --git a/Documentation/devicetree/bindings/mfd/ti-keystone-devctrl.txt b/Documentation/devicetree/bindings/mfd/ti-keystone-devctrl.txt
new file mode 100644
index 0000000..35f7a66
--- /dev/null
+++ b/Documentation/devicetree/bindings/mfd/ti-keystone-devctrl.txt
@@ -0,0 +1,19 @@
+* Device tree bindings for Texas Instruments keystone device state control
+
+The Keystone II devices have a set of registers that are used to control
+the status of its peripherals. This node is intended to allow access to
+this functionality.
+
+Required properties:
+
+- compatible:		"ti,keystone-devctrl", "syscon"
+
+- reg:			contains offset/length value for pll controller
+			registers space.
+
+Example:
+
+devctrl: device-state-control {
+	compatible = "ti,keystone-devctrl", "syscon";
+	reg = <0x02620000 0x1000>;
+};
-- 
1.8.3.2




More information about the linux-arm-kernel mailing list