[PATCH v3 5/5] ARM: dts: enable hdmi for exynos5800 based peach-pi board

[Rahul Sharma]

On 12 May 2014 16:22, Arun Kumar K <arun.kk at samsung.com> wrote:
> Hi Rahul,
>
> On 05/12/14 15:54, Rahul Sharma wrote:
>> From: Rahul Sharma <Rahul.Sharma at samsung.com>
>>
>> Enable hdmi for peach-pi board.
>>
>> Signed-off-by: Rahul Sharma <Rahul.Sharma at samsung.com>
>> ---
>>  arch/arm/boot/dts/exynos5800-peach-pi.dts |   26 ++++++++++++++++++++++++++
>>  1 file changed, 26 insertions(+)
>>
>> diff --git a/arch/arm/boot/dts/exynos5800-peach-pi.dts b/arch/arm/boot/dts/exynos5800-peach-pi.dts
>> index 742655b..bbb445a 100644
>> --- a/arch/arm/boot/dts/exynos5800-peach-pi.dts
>> +++ b/arch/arm/boot/dts/exynos5800-peach-pi.dts
>> @@ -72,6 +72,13 @@
>>               samsung,pin-pud = <0>;
>>               samsung,pin-drv = <0>;
>>       };
>> +
>> +     hdmi_hpd_irq: hdmi-hpd-irq {
>> +             samsung,pins = "gpx3-7";
>> +             samsung,pin-function = <0>;
>> +             samsung,pin-pud = <1>;
>> +             samsung,pin-drv = <0>;
>> +     };
>
> This node is already added in 5420-pinctrl.dtsi in patch 3/5.
> You can drop it from here.
>

yea correct. I will remove this pin.

Regards,
Rahul Sharma.

> Regards
> Arun
>
>>  };
>>
>>  &rtc {
>> @@ -134,6 +141,25 @@
>>       };
>>  };
>>
>> +&i2c_2 {
>> +     status = "okay";
>> +     samsung,i2c-sda-delay = <100>;
>> +     samsung,i2c-max-bus-freq = <66000>;
>> +     samsung,i2c-slave-addr = <0x50>;
>> +
>> +     hdmiddc at 50 {
>> +             reg = <0x50>;
>> +     };
>> +};
>> +
>> +&hdmi {
>> +     status = "okay";
>> +     hpd-gpio = <&gpx3 7 2>;
>> +     pinctrl-names = "default";
>> +     pinctrl-0 = <&hdmi_hpd_irq>;
>> +     ddc = <&i2c_2>;
>> +};
>> +
>>  /*
>>   * Use longest HW watchdog in SoC (32 seconds) since the hardware
>>   * watchdog provides no debugging information (compared to soft/hard
>>