[RFC PATCH 1/4] memory: tegra124-emc: Add EMC driver

Stephen Warren swarren at wwwdotorg.org
Tue Jun 17 09:15:50 PDT 2014


On 06/17/2014 06:16 AM, Tomeu Vizoso wrote:
> On 06/16/2014 10:02 PM, Stephen Warren wrote:
>> On 06/16/2014 07:35 AM, Tomeu Vizoso wrote:

>> This binding looks quite anaemic vs.
>> Documentation/devicetree/bindings/arm/tegra/nvidia,tegra20-emc.txt; I
>> would expect that this binding needs all the EMC register data from the
>> tegra20-emc binding too. Can the two bindings be identical?
> 
> There's even less stuff needed right now, as all what ultimately the EMC
> driver does is call clk_set_rate on the EMC clock. As the T124 EMC
> driver gains more features, they should get more similar.

IIRC, even changing the EMC clock rate requires modifying the memory
controller's programming (e.g. delays/taps/tuning etc.). That's exactly
what the more complex stuff in the nvidia,tegra20-emc.txt is all about.
I not convinced that a driver that just modifies the clock rate without
adjusting the EMC programming will work reliably.

>>> +#ifdef CONFIG_TEGRA124_EMC
>>> +int tegra124_emc_reserve_bandwidth(unsigned int consumer, unsigned
>>> long rate);
>>> +void tegra124_emc_set_floor(unsigned long freq);
>>> +void tegra124_emc_set_ceiling(unsigned long freq);
>>> +#else
>>> +int tegra124_emc_reserve_bandwidth(unsigned int consumer, unsigned
>>> long rate)
>>> +{ return -ENODEV; }
>>> +void tegra124_emc_set_floor(unsigned long freq)
>>> +{ return; }
>>> +void tegra124_emc_set_ceiling(unsigned long freq)
>>> +{ return; }
>>> +#endif
>>
>> I'll repeat what I said off-list so that we can have the whole
>> conversation on the list:
>>
>> That looks like a custom Tegra-specific API. I think it'd be much better
>> to integrate this into the common clock framework as a standard clock
>> constraints API. There are other use-cases for clock constraints besides
>> EMC scaling (e.g. some in audio on Tegra, and I'm sure many on other
>> SoCs too).
> 
> Yes, I wrote a bit in the cover letter about our requirements and how
> they map to the CCF. Could you please comment on that?

My comments remain the same. I believe this is something that belongs in
the clock driver, or at the least, some API that takes a struct clock as
its parameter, so that drivers can use the existing DT clock lookup
mechanism.



More information about the linux-arm-kernel mailing list