[PATCH v5 0/2] i2c: sunxi: add P2WI controller support

[Boris BREZILLON]

Hello,

This series adds support for the P2WI block used by some Allwinner boards
to interface with the AXP221 PMIC.

Best Regards,

Boris

Changes since v4:
- add P2WI protocol description in driver header comment
- remove unneeded i2c address check
- remove unneeded irq field from p2wi struct

Changes since v3:
- update the DT bindings doc
- fix a comment that was no longer true

Changes since v2:
- drop the initialization (switch from I2C to P2WI mode) part
- print devm_ioremap_resource err code

Boris BREZILLON (2):
  i2c: sunxi: add P2WI DT bindings documentation
  i2c: sunxi: add P2WI (Push/Pull 2 Wire Interface) controller support

 .../devicetree/bindings/i2c/i2c-sunxi-p2wi.txt     |  41 +++
 drivers/i2c/busses/Kconfig                         |  12 +
 drivers/i2c/busses/Makefile                        |   1 +
 drivers/i2c/busses/i2c-sun6i-p2wi.c                | 356 +++++++++++++++++++++
 4 files changed, 410 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/i2c/i2c-sunxi-p2wi.txt
 create mode 100644 drivers/i2c/busses/i2c-sun6i-p2wi.c

-- 
1.8.3.2