[PATCH v11 0/2] Add support for the Allwinner A31 DMA Controller

[Russell King - ARM Linux]

On Fri, Jul 25, 2014 at 06:37:46PM +0200, Maxime Ripard wrote:
> Hi Vinod,
> 
> On Fri, Jul 25, 2014 at 06:42:17PM +0530, Vinod Koul wrote:
> > - don't use devm_request_irq(). You have irq enabled and you have killed
> >   tasklet. This is too racy. You need to ensure no irqs can be generated before killing
> >   tasklets.
> 
> Ok, would calling disable_irq before killing the tasklet an option for
> you ? that would allow to keep the devm_request_irq.

That's not really an acceptable approach if you can use shared interrupts.
A better alternative would be devm_free_irq() to give a definite point
that the interrupt is unregistered in the driver remove sequence.  That
allows you to keep the advantage of devm_request_irq() to clean up during
the initialisation side.

An alternative approach would be to ensure that the hardware is quiesced,
and interrupts are disabled.  Then call synchronize_irq() on it, and at
that point, you should be certain that your interrupt handler should not
process any further interrupts for your device (though, in a shared
interrupt environment, it would still be called should a different device
on the shared line raise its interrupt.)

-- 
FTTC broadband for 0.8mile line: currently at 9.5Mbps down 400kbps up
according to speedtest.net.