[PATCH v1 1/3] gpio: Add APM X-Gene standby GPIO controller driver

[Y Vo]

On Wed, Oct 29, 2014 at 10:16 PM, Arnd Bergmann <arnd at arndb.de> wrote:
> On Wednesday 29 October 2014 22:09:00 Y Vo wrote:
>> Hi Arnd,
>>
>> Per Linus, shall we hold this driver until the GIC submission complete
>> ? Or we will send the version without access GIC to read status in
>> case the GPIO is configured IRQ ?
>
> I'm fine with it either way.
>
>> +static int xgene_gpio_sb_get(struct gpio_chip *gc, u32 gpio)
>> +{
>> +       struct of_mm_gpio_chip *mm_gc = to_of_mm_gpio_chip(gc);
>> +       struct xgene_gpio_sb *chip = to_xgene_gpio_sb(mm_gc);
>> +       u32 data;
>> +
>> +       data = ioread32(mm_gc->regs + MPA_GPIO_IN_ADDR);
>> +
>> +       return (data &  GPIO_MASK(gpio)) ? 1 : 0;
>> +}
>
> This would be actually broken, right? Maybe it's better to change the
> driver so that it refuses to map GPIO lines that are hardwired to
> the interrupt controller, until we can support that.

It still works if they are configure as GPIO.
Do you have any reference to resolve it ?