[PATCH v5 1/5] phy: add a driver for the Rockchip SoC internal USB2.0 PHY

[Yunzhi Li]

Hi Kishon:

On 2014/12/11 14:02, Kishon Vijay Abraham I wrote:
> Hi,
>
> On Wednesday 10 December 2014 04:16 PM, Yunzhi Li wrote:
>> This patch to add a generic PHY driver for ROCKCHIP usb PHYs,
>> currently this driver can support RK3288. The RK3288 SoC have
>> three independent USB PHY IPs which are all configured through a
>> set of registers located in the GRF (general register files)
>> module.
>>
>> Signed-off-by: Yunzhi Li <lyz at rock-chips.com>
>>
>> +
>> +#define ROCKCHIP_RK3288_UOC(n)	(0x320 + n * 0x14)
>> +
>> +/*
>> + * The higher 16-bit of this register is used for write protection
>> + * only if BIT(13 + 16) set to 1 the BIT(13) can be written.
>> + */
>> +#define SIDDQ_MSK		BIT(13 + 16)
> I think here the "MSK" is misleading. it should be something that refers write
> protection?
So, #define SIDDQ_WRITE_ENA  BIT(29) , could be ok ?
>> +#define SIDDQ_ON		BIT(13)
>> +#define SIDDQ_OFF		(0 << 13)
>> +
>> +struct rockchip_usb_phy {
>> +	struct regmap	*reg_base;
>> +	unsigned int	reg_offset;
>> +	struct clk	*clk;
>> +	struct phy	*phy;
>> +	unsigned	index;
>> +};
>> +
>> +struct rockchip_usb_phy_priv {
>> +	struct rockchip_usb_phy	*phys;
>> +	unsigned		nphys;
>> +};
>> +
>> +static int rockchip_usb_phy_power(struct rockchip_usb_phy *phy,
>> +					   bool siddq)
>> +{
>> +	return regmap_write(phy->reg_base, phy->reg_offset,
>> +			    SIDDQ_MSK | (siddq ? SIDDQ_ON : SIDDQ_OFF));
> Shouldn't we actually reset the bit for power off?
Sorry, which bit you refer to here  and why should it be reset? could 
you give more infomation.

---
Yunzhi Li @ rockchip