[PATCH] PWM: atmel-pwm: use request/free instead of enable/disable

[Alexandre Belloni]

I found that disabling a pwm while it is at a low level will actually put it
back at a high level. The main symptom is that leds-pwm is calling pwm_disable()
after setting the duty cycle to 0. Hence, instead of getting a switched off LED,
you get an LED lit up at full brightness.

Solve that by using the request and free callbacks to enable and disable the
pwm channels and the clock.

Signed-off-by: Alexandre Belloni <alexandre.belloni at free-electrons.com>
---

This patch applies after:
  [PATCH v4] PWM: atmel-pwm: add PWM controller driver

 drivers/pwm/pwm-atmel.c | 14 +++++---------
 1 file changed, 5 insertions(+), 9 deletions(-)

diff --git a/drivers/pwm/pwm-atmel.c b/drivers/pwm/pwm-atmel.c
index 6af7a50..4526e71 100644
--- a/drivers/pwm/pwm-atmel.c
+++ b/drivers/pwm/pwm-atmel.c
@@ -209,7 +209,7 @@ static int atmel_pwm_set_polarity(struct pwm_chip *chip, struct pwm_device *pwm,
 	return 0;
 }
 
-static int atmel_pwm_enable(struct pwm_chip *chip, struct pwm_device *pwm)
+static int atmel_pwm_request(struct pwm_chip *chip, struct pwm_device *pwm)
 {
 	struct atmel_pwm_chip *atmel_pwm = to_atmel_pwm_chip(chip);
 	int ret;
@@ -225,23 +225,19 @@ static int atmel_pwm_enable(struct pwm_chip *chip, struct pwm_device *pwm)
 	return 0;
 }
 
-static void atmel_pwm_disable(struct pwm_chip *chip, struct pwm_device *pwm)
+static void atmel_pwm_free(struct pwm_chip *chip, struct pwm_device *pwm)
 {
 	struct atmel_pwm_chip *atmel_pwm = to_atmel_pwm_chip(chip);
-	u32 val;
 
 	atmel_pwm_writel(atmel_pwm, PWM_DIS, 1 << pwm->hwpwm);
-
-	val = atmel_pwm_readl(atmel_pwm, PWM_SR);
-	if ((val & PWM_SR_ALL_CH_ON) == 0)
-		clk_disable(atmel_pwm->clk);
+	clk_disable(atmel_pwm->clk);
 }
 
 static const struct pwm_ops atmel_pwm_ops = {
 	.config = atmel_pwm_config,
 	.set_polarity = atmel_pwm_set_polarity,
-	.enable = atmel_pwm_enable,
-	.disable = atmel_pwm_disable,
+	.request = atmel_pwm_request,
+	.free = atmel_pwm_free,
 	.owner = THIS_MODULE,
 };
 
-- 
1.8.1.2