[PATCH] ARM: mvebu: Add DT entry for ReadyNAS Duo v2 to use gpio-poweroff driver

[Arnaud Ebalard]

Without that fix, at the end of the shutdown process, the board is
still powered (led glowing, fan running, ...).

Signed-off-by: Arnaud Ebalard <arno at natisbad.org>
---
Hi,

I have prepared some cleanup patches for existing ReadyNAS .dts files
which I intend to send for review in the next fex days. The GPIO
voltage level is still a value below but the cleanup patch for this
.dts will handle that globally.

 arch/arm/boot/dts/kirkwood-netgear_readynas_duo_v2.dts | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/arch/arm/boot/dts/kirkwood-netgear_readynas_duo_v2.dts b/arch/arm/boot/dts/kirkwood-netgear_readynas_duo_v2.dts
index e6a102c..4e3cae1 100644
--- a/arch/arm/boot/dts/kirkwood-netgear_readynas_duo_v2.dts
+++ b/arch/arm/boot/dts/kirkwood-netgear_readynas_duo_v2.dts
@@ -60,6 +60,10 @@
 				marvell,pins = "mpp29";
 				marvell,function = "gpio";
 			};
+			pmx_poweroff: pmx-poweroff {
+				marvell,pins = "mpp30";
+				marvell,function = "gpio";
+			};
 		};
 
 		clocks {
@@ -158,6 +162,13 @@
 		};
 	};
 
+	gpio-poweroff {
+		compatible = "gpio-poweroff";
+		pinctrl-0 = <&pmx_poweroff>;
+		pinctrl-names = "default";
+		gpios = <&gpio0 30 1>;
+	};
+
         regulators {
                 compatible = "simple-bus";
                 #address-cells = <1>;
-- 
1.8.4.rc3