[PATCH 02/10] mtd: st_spi_fsm: Supply all register address and bit logic defines

Mark Brown broonie at kernel.org
Mon Nov 18 12:22:43 EST 2013


On Mon, Nov 18, 2013 at 04:02:26PM +0000, Lee Jones wrote:
> On Mon, 18 Nov 2013, Mark Brown wrote:

> > Like I say I'm suggesting that the bit of the code that understands the
> > flash chip is separate to the bit of code that knows the mechanics of
> > sending commands and data to the chip.

> The issue is that almost the entire driver is controller side. The
> only bits that are the same (and not in all cases) are the OPCODEs,
> but they are one liners (21 lines out of 1153). Most of the
> controllers which use this stuff could reuse quite a bit of the m25p80
> driver as they just write the message containing the OPCODE as the
> m25p80 driver sets it up, but that's simply not the case with our
> controller. We would have to pull the OPCODE out and based on which
> one it is, we'd have to build our own message.

OK, so then perhaps the abstraction here is simply to export the table
with the opcodes from the m25p80 driver so that when someone comes along
and adds a new chip they can just add it there and other drivers will
get the update too.

> Put it this way, if we tried to use the m25p80 our controller driver
> would most likely be twice as large and twice as complex as it is
> currently, which is exactly the inverse of what we're trying to
> achieve here.

If we're having to add new flashes to multiple drivers I'd not say we're
winning.
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 836 bytes
Desc: Digital signature
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20131118/36fe5722/attachment.sig>


More information about the linux-arm-kernel mailing list