[PATCH v6] ARM:dts:omap4-panda: Update the LED support for the panda DTS

Dan Murphy dmurphy at ti.com
Fri May 17 12:02:32 EDT 2013


The GPIO for LED D1 on the omap4-panda a1-a3 rev and the omap4-panda-es
are different.

A1-A3 = gpio_wk7
ES = gpio_110

There is no change to LED D2

Abstract away the pinmux and the LED definitions for the two boards into
the respective DTS files.

Signed-off-by: Dan Murphy <dmurphy at ti.com>
---
Changes in this version:
	- review comments incorporated.
Previous version of this patch was discussed in:
	https://patchwork.kernel.org/patch/2582771/

 arch/arm/boot/dts/omap4-panda-common.dtsi |   16 +++++++++++++++-
 arch/arm/boot/dts/omap4-panda-es.dts      |   28 ++++++++++++++++++++++++++++
 2 files changed, 43 insertions(+), 1 deletions(-)

diff --git a/arch/arm/boot/dts/omap4-panda-common.dtsi b/arch/arm/boot/dts/omap4-panda-common.dtsi
index 03bd60d..5fd59b3 100644
--- a/arch/arm/boot/dts/omap4-panda-common.dtsi
+++ b/arch/arm/boot/dts/omap4-panda-common.dtsi
@@ -16,8 +16,13 @@
 		reg = <0x80000000 0x40000000>; /* 1 GB */
 	};
 
-	leds {
+	leds: leds {
 		compatible = "gpio-leds";
+		pinctrl-names = "default";
+		pinctrl-0 = <
+			&led_wkgpio_pins
+		>;
+
 		heartbeat {
 			label = "pandaboard::status1";
 			gpios = <&gpio1 7 0>;
@@ -137,6 +142,15 @@
 	};
 };
 
+&omap4_pmx_wkup {
+	led_wkgpio_pins: pinmux_leds_wkpins {
+		pinctrl-single,pins = <
+			0x1a 0x3	/* gpio_wk7 OUTPUT | MODE 3 */
+			0x1c 0x3	/* gpio_wk8 OUTPUT | MODE 3 */
+		>;
+	};
+};
+
 &i2c1 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&i2c1_pins>;
diff --git a/arch/arm/boot/dts/omap4-panda-es.dts b/arch/arm/boot/dts/omap4-panda-es.dts
index f1d8c21..c968a3b 100644
--- a/arch/arm/boot/dts/omap4-panda-es.dts
+++ b/arch/arm/boot/dts/omap4-panda-es.dts
@@ -34,3 +34,31 @@
 		0x5e 0x100	/* hdmi_sda.hdmi_sda INPUT | MODE 0 */
 		>;
 };
+
+&omap4_pmx_core {
+	led_gpio_pins: gpio_led_pmx {
+		pinctrl-single,pins = <
+			0xb6 0x3	/* gpio_110 OUTPUT | MODE 3 */
+		>;
+	};
+};
+
+&led_wkgpio_pins {
+	pinctrl-single,pins = <
+		0x1c 0x3	/* gpio_wk8 OUTPUT | MODE 3 */
+	>;
+};
+
+&leds {
+	pinctrl-0 = <
+		&led_gpio_pins
+		&led_wkgpio_pins
+	>;
+
+	heartbeat {
+		gpios = <&gpio4 14 0>;
+	};
+	mmc {
+		gpios = <&gpio1 8 0>;
+	};
+};
-- 
1.7.5.4




More information about the linux-arm-kernel mailing list