[PATCH 2/2] ARM: shmobile: Lager: conditionally select CONFIG_MICREL_PHY

[Simon Horman]

On Fri, Dec 20, 2013 at 02:20:54AM +0300, Sergei Shtylyov wrote:
> Now that support for KSZ8041RNLI is added to the Micrel PHY driver and we intend
> to support PHY IRQs on the Lager board, we have to enable the Micrel driver.
> Do this by selecting CONFIG_MICREL_PHY for Lager if CONFIG_SH_ETH is enabled.
> 
> Signed-off-by: Sergei Shtylyov <sergei.shtylyov at cogentembedded.com>

Hi Sergei,

while I am very happy to see this change unfortunately it no longer
applies. Could you please rebase it on top of
renesas-devel-v3.13-rc4-20131219?

Thanks

> 
> ---
>  arch/arm/mach-shmobile/Kconfig |    2 ++
>  1 file changed, 2 insertions(+)
> 
> Index: renesas/arch/arm/mach-shmobile/Kconfig
> ===================================================================
> --- renesas.orig/arch/arm/mach-shmobile/Kconfig
> +++ renesas/arch/arm/mach-shmobile/Kconfig
> @@ -54,6 +54,7 @@ config MACH_KZM9D
>  config MACH_LAGER
>  	bool "Lager board"
>  	depends on ARCH_R8A7790
> +	select MICREL_PHY if SH_ETH
>  
>  comment "Renesas ARM SoCs System Configuration"
>  endif
> @@ -261,6 +262,7 @@ config MACH_LAGER
>  	bool "Lager board"
>  	depends on ARCH_R8A7790
>  	select USE_OF
> +	select MICREL_PHY if SH_ETH
>  
>  config MACH_KOELSCH
>  	bool "Koelsch board"
>