[PATCH 0/2] Full DT IRQ support for versatile

Grant Likely grant.likely at secretlab.ca
Thu Jan 12 21:31:54 EST 2012


On Fri, Jan 13, 2012 at 01:42:50AM +0000, Jamie Iles wrote:
> On Thu, Jan 12, 2012 at 06:20:37PM -0700, Grant Likely wrote:
> > On Thu, Jan 12, 2012 at 5:43 PM, Jamie Iles <jamie at jamieiles.com> wrote:
> > > These patches move versatile over to instantiating both interrupt
> > > controllers from the device tree.  I've tested this in qemu for both DT
> > > and non-DT platforms but only with an initramfs.  I've seen interrupts
> > > generated on both controllers for both boot methods.
> > >
> > > Grant, Rob, this makes use of irqdomain again as I'm not sure what the
> > > replacement is going to look like yet.  versatile works with DT in
> > > mainline, but that's kind of lucky...  I know there's been patches to
> > > make irq_domain_add_simple() return the irq_domain and can rebase if
> > > needed.
> > 
> > I posted the patches for finishing up irq_domain migration yesterday.
> > irq_domain_add_simple() can trivially be changed to
> > irq_domain_add_legacy. I'll try out these
> > patches on top of my irqdomain/next branch
> 
> Excellent!  I've just grabbed your branch and given it a spin.  I fixed 
> up my patches with the patch below and had to revert "irqdesc: 
> Consolidate irq reservation logic" as I saw Rob mentioned as I was 
> getting negative irq_desc's allocated but otherwise it works nicely!
> 
> I've also tested your tree with the irqdesc patch reverted on picoxcell 
> and that's working nicely too!
> 
> Jamie
> 
> 8<----
> 
> diff --git a/arch/arm/plat-versatile/fpga-irq.c b/arch/arm/plat-versatile/fpga-irq.c
> index fd87b06..c4dac93 100644
> --- a/arch/arm/plat-versatile/fpga-irq.c
> +++ b/arch/arm/plat-versatile/fpga-irq.c
> @@ -59,10 +59,9 @@ void __init fpga_irq_init(int parent_irq, u32 valid, struct fpga_irq_data *f)
>  	f->chip.irq_ack = fpga_irq_mask;
>  	f->chip.irq_mask = fpga_irq_mask;
>  	f->chip.irq_unmask = fpga_irq_unmask;
> -	f->domain.irq_base = f->irq_start;
> -	f->domain.nr_irq = 32;
> -	f->domain.ops = &irq_domain_simple_ops;
> -	irq_domain_add(&f->domain);
> +	if (!f->domain)
> +		f->domain = irq_domain_add_legacy(NULL, 32, f->irq_start,
> +						  0, &irq_domain_simple_ops);
>  
>  	if (parent_irq != -1) {
>  		irq_set_handler_data(parent_irq, f);
> @@ -103,7 +102,8 @@ int __init sic_of_init(struct device_node *np, struct device_node *parent)
>  		err = sic_data->irq_start;
>  		goto out_unmap;
>  	}
> -	sic_data->domain.of_node = of_node_get(np);
> +	sic_data->domain = irq_domain_add_legacy(np, 32, sic_data->irq_start,
> +						 0, &irq_domain_simple_ops);

For the DT use-case, you should try irq_domain_add_linear(np, 32);
which makes the controller use irqs allocated only when they are
requested.




More information about the linux-arm-kernel mailing list