[PATCH 04/11] ARM: OMAP: board-am3517evm: Configure McBSP1 CLKR/FSR signal source

Peter Ujfalusi peter.ujfalusi at ti.com
Wed Aug 8 05:11:34 EDT 2012


am3517evm board uses McBSP1 for audio with 4pin configuration.
The CLKR/FSR signals need to be connected to CLKX/FSX pin of the SoC in
this case.

Signed-off-by: Peter Ujfalusi <peter.ujfalusi at ti.com>
---
 arch/arm/mach-omap2/board-am3517evm.c |   13 +++++++++++++
 1 files changed, 13 insertions(+), 0 deletions(-)

diff --git a/arch/arm/mach-omap2/board-am3517evm.c b/arch/arm/mach-omap2/board-am3517evm.c
index 18f6010..592812a 100644
--- a/arch/arm/mach-omap2/board-am3517evm.c
+++ b/arch/arm/mach-omap2/board-am3517evm.c
@@ -264,6 +264,16 @@ static __init void am3517_evm_musb_init(void)
 	usb_musb_init(&musb_board_data);
 }
 
+static __init void am3517_evm_mcbsp1_init(void)
+{
+	u32 devconf0;
+
+	/* McBSP1 CLKR/FSR signal to be connected to CLKX/FSX pin */
+	devconf0 = omap_ctrl_readl(OMAP2_CONTROL_DEVCONF0);
+	devconf0 |=  OMAP2_MCBSP1_CLKR_MASK | OMAP2_MCBSP1_FSR_MASK;
+	omap_ctrl_writel(devconf0, OMAP2_CONTROL_DEVCONF0);
+}
+
 static const struct usbhs_omap_board_data usbhs_bdata __initconst = {
 	.port_mode[0] = OMAP_EHCI_PORT_MODE_PHY,
 #if defined(CONFIG_PANEL_SHARP_LQ043T1DG01) || \
@@ -373,6 +383,9 @@ static void __init am3517_evm_init(void)
 	/* MUSB */
 	am3517_evm_musb_init();
 
+	/* McBSP1 */
+	am3517_evm_mcbsp1_init();
+
 	/* MMC init function */
 	omap_hsmmc_init(mmc);
 }
-- 
1.7.8.6




More information about the linux-arm-kernel mailing list