[PATCH] ARM: S3C64XX: Configure backup battery charger on Cragganmore

[Mark Brown]

Signed-off-by: Mark Brown <broonie at opensource.wolfsonmicro.com>
---
 arch/arm/mach-s3c64xx/mach-crag6410.c |    8 ++++++++
 1 files changed, 8 insertions(+), 0 deletions(-)

diff --git a/arch/arm/mach-s3c64xx/mach-crag6410.c b/arch/arm/mach-s3c64xx/mach-crag6410.c
index 3ba6e93..5995c77 100644
--- a/arch/arm/mach-s3c64xx/mach-crag6410.c
+++ b/arch/arm/mach-s3c64xx/mach-crag6410.c
@@ -497,6 +497,12 @@ static struct regulator_init_data vddalive __initdata = {
 	.supply_regulator = "WALLVDD",
 };
 
+static struct wm831x_backup_pdata banff_backup_pdata __initdata = {
+	.charger_enable = 1,
+	.vlim = 2500,  /* mV */
+	.ilim = 200,   /* uA */
+};
+
 static struct wm831x_status_pdata banff_red_led __initdata = {
 	.name = "banff:red:",
 	.default_src = WM831X_STATUS_MANUAL,
@@ -517,6 +523,8 @@ static struct wm831x_pdata crag_pmic_pdata __initdata = {
 	.irq_base = BANFF_PMIC_IRQ_BASE,
 	.gpio_base = GPIO_BOARD_START + 8,
 
+	.backup = &banff_backup_pdata,
+
 	.gpio_defaults = {
 		/* GPIO11: Touchscreen data - CMOS, DBVDD, active high*/
 		[10] = WM831X_GPN_POL | WM831X_GPN_ENA | 0x6,
-- 
1.7.5.4