[PATCH] omap4: Fix ULPI PHY init for ES1.0 SDP (Re: 4430SDP boot failure)

[Tony Lindgren]

* Anand Gadiyar <gadiyar at ti.com> [110202 10:51]:
> Tony Lindgren wrote:
> > * Anand Gadiyar <gadiyar at ti.com> [110201 04:54]:
> > >
> > > I believe this fix is fixing your reboot issue, but it's breaking
> > > EHCI support on the SDP.
> > >
> > > The MODE4 above should really be MODE3 - all GPIOs are on MODE3.
> > > By changing
> > >
> > > The patch snippet below fixes EHCI on the SDP, but I believe that
> > > making this change will reintroduce the "board reboots" issue
> > > you originally reported. Could you check and tell me if this
> > > is the case?
> >
> > Hmm sorry looks like I made a typo there. That should be fixed.
> >
> > > Just curious - is your board a Blaze, or an SDP?
> >
> > It's a ES1.0 blaze, with the patch below it reboots early
> > during the boot. I also have to disable omap_l2_cache_init
> > on this board to get it to boot.
> >
> 
> ...
> 
> > Maybe there should be a check for ES1.0 for the USB also?
> 
> Looks like a bug on the Blaze boards. There's a large capacitor
> on the rails that starts charging when we try to power the USB PHY.
> The inrush current is quite high and this causes the reboot.
> 
> The capacitor is on the big motherboard called the application
> board, so it's independent of the silicon rev. I'm not sure
> which revs are affected - I'll try and find out more about the
> issue to see if I can come up with a better fix.

OK thanks.

Tony