[PATCH] omap: boards w/ wl12xx should select REGULATOR_FIXED_VOLTAGE

[Ohad Ben-Cohen]

Hi Tony,

On Wed, Nov 24, 2010 at 12:04 PM, Ohad Ben-Cohen <ohad at wizery.com> wrote:
> Power to the wl12xx wlan device is controlled by a fixed regulator.
>
> Boards that have the wl12xx should select REGULATOR_FIXED_VOLTAGE so
> users will not be baffled.

Not sure if you picked this up ?

We need it because otherwise new wl12xx users can spend many hours
until they figure out what's the problem..

Please tell me if there's any problem with this one.

Thanks,
Ohad.

>
> Signed-off-by: Ohad Ben-Cohen <ohad at wizery.com>
> ---
>  arch/arm/mach-omap2/Kconfig |    3 +++
>  1 files changed, 3 insertions(+), 0 deletions(-)
>
> diff --git a/arch/arm/mach-omap2/Kconfig b/arch/arm/mach-omap2/Kconfig
> index fc3a181..cc386da 100644
> --- a/arch/arm/mach-omap2/Kconfig
> +++ b/arch/arm/mach-omap2/Kconfig
> @@ -190,6 +190,7 @@ config MACH_OMAP3_PANDORA
>        depends on ARCH_OMAP3
>        default y
>        select OMAP_PACKAGE_CBB
> +       select REGULATOR_FIXED_VOLTAGE
>
>  config MACH_OMAP3_TOUCHBOOK
>        bool "OMAP3 Touch Book"
> @@ -235,6 +236,7 @@ config MACH_OMAP_ZOOM2
>        select SERIAL_8250
>        select SERIAL_CORE_CONSOLE
>        select SERIAL_8250_CONSOLE
> +       select REGULATOR_FIXED_VOLTAGE
>
>  config MACH_OMAP_ZOOM3
>        bool "OMAP3630 Zoom3 board"
> @@ -244,6 +246,7 @@ config MACH_OMAP_ZOOM3
>        select SERIAL_8250
>        select SERIAL_CORE_CONSOLE
>        select SERIAL_8250_CONSOLE
> +       select REGULATOR_FIXED_VOLTAGE
>
>  config MACH_CM_T35
>        bool "CompuLab CM-T35 module"
> --
> 1.7.0.4
>
>