[PATCH 2/2] arm64: dts: meson: add initial device-tree for Tanix TX9 Pro

[Martin Blumenstingl]

On Sat, Sep 27, 2025 at 2:50 PM Christian Hewitt
<christianshewitt at gmail.com> wrote:
>
> Oranth Tanix TX9 Pro is based on the Amlogic Q200 reference design with
> an S912 chip and the following specs:
>
> - 3GB DDR3 RAM
> - 32GB eMMC
> - 10/100/1000 Base-T Ethernet
> - AP6356 Wireless (802.11 b/g/n/ac, BT 5.0)
> - HDMI 2.0a video
> - VFD for clock/status
> - 2x USB 2.0 ports
> - IR receiver
> - 1x Power LED (white)
> - 1x Update/Reset button (underside)
> - 1x micro SD card slot
>
> Signed-off-by: Christian Hewitt <christianshewitt at gmail.com>
Reviewed-by: Martin Blumenstingl <martin.blumenstingl at googlemail.com>

> ---
> Checkpatch generates the 'phy-mode "rgmii" without comment'
> warning but this dts is using the same rgmii format as all
> other Amlogic boards, so I have omitted a comment.
So far we've been mimicking the vendor kernel (which sets up the MAC
to generate the delays and disables them on PHY level).
If we change it we should do so for all devices.


Best regards,
Martin