[PATCH v5 3/6] documentation: media: Add documentation for new RGB and YUV bus formats

Neil Armstrong narmstrong at baylibre.com
Fri Mar 31 06:45:38 PDT 2017


On 03/31/2017 03:14 PM, Hans Verkuil wrote:
> On 30/03/17 11:04, Neil Armstrong wrote:
>> Add documentation for added Bus Formats to describe RGB and YUV formats used
>> as input to the Synopsys DesignWare HDMI TX Controller.
>>
>> Signed-off-by: Neil Armstrong <narmstrong at baylibre.com>
>> ---
>>  Documentation/media/uapi/v4l/subdev-formats.rst | 871 +++++++++++++++++++++++-
>>  1 file changed, 857 insertions(+), 14 deletions(-)
> 
> This looks good, but the "Packed YUV Formats" documentation should be updated.
> 
> Currently this says:
> 
> -  The number of bus samples per pixel. Pixels that are wider than the
>    bus width must be transferred in multiple samples. Common values are
>    1, 1.5 (encoded as 1_5) and 2.
> 
> I propose this change:
> 
> -  The number of bus samples per pixel. Pixels that are wider than the
>    bus width must be transferred in multiple samples. Common values are
>    0.5 (encoded as 0_5; in this case two pixels are transferred per bus
>    sample), 1, 1.5 (encoded as 1_5) and 2.
> 
> With that additional change you can add my:
> 
> Acked-by: Hans Verkuil <hans.verkuil at cisco.com>
> 
> Regards,
> 
> 	Hans
> 

Hi Hans,

Thanks for the hint, I will change this and post a v5.1 with your acks.

Neil



More information about the linux-amlogic mailing list