[PATCH v2 5/6] ARM64: meson-gxbb-p20x: Enable USB Nodes

[Kevin Hilman]

Kevin Hilman <khilman at baylibre.com> writes:

> Martin Blumenstingl <martin.blumenstingl at googlemail.com> writes:
>
>> From: Jerome Brunet <jbrunet at baylibre.com>
>>
>> Enable both gxbb USB controller and add a 5V regulator for the OTG port
>> VBUS
>>
>> Signed-off-by: Jerome Brunet <jbrunet at baylibre.com>
>
> nit: subject should have "ARM64: dts:" prefix.
>
>> ---
>>  arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi | 29 ++++++++++++++++++++++++
>>  1 file changed, 29 insertions(+)
>>
>> diff --git a/arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi b/arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi
>> index ce105fe..4493bce 100644
>> --- a/arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi
>> +++ b/arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi
>> @@ -93,6 +93,18 @@
>>  		compatible = "mmc-pwrseq-emmc";
>>  		reset-gpios = <&gpio BOOT_9 GPIO_ACTIVE_LOW>;
>>  	};
>> +
>> +	usb_vbus: regulator-usb0-vbus {
>
> nit: I like to use the signal name from the schematics for the node name
> (and for regulator-name below).  In the schematics, that signal is named
> USB_PWR.
>
>
>> +		compatible = "regulator-fixed";
>> +
>> +		regulator-name = "USB0_VBUS";
>> +		regulator-min-microvolt = <5000000>;
>> +		regulator-max-microvolt = <5000000>;
>> +
>> +		gpio = <&gpio GPIODV_24 GPIO_ACTIVE_HIGH>;
>
> Please add a comment above this line with the schematic signal name: USB_PWR_EN.
>

For the record... after a chat with Martin on IRC, I just fixed these up
myself locally, so...

Applied,

Kevin