[PATCH 01/10 net-next v3] ipv6: convert CONFIG_IPV6 to built-in only and clean up Kconfigs

[Ricardo B. Marlière]

On Wed Mar 18, 2026 at 3:51 AM -03, Krzysztof Kozlowski wrote:
> On 17/03/2026 15:00, Fernando Fernandez Mancera wrote:
>> Maintaining a modular IPv6 stack offers image size savings for specific
>> setups, this benefit is outweighed by the architectural burden it
>> imposes on the subsystems on implementation and maintenance. Therefore,
>> drop it.
>> 
>> Change CONFIG_IPV6 from tristate to bool. Remove all Kconfig
>> dependencies across the tree that explicitly checked for IPV6=m. In
>> addition, remove MODULE_DESCRIPTION(), MODULE_ALIAS(), MODULE_AUTHOR()
>> and MODULE_LICENSE().
>> 
>> This is also replacing module_init() by device_initcall(). It is not
>> possible to use fs_initcall() as IPv4 does because that creates a race
>> condition on IPv6 addrconf.
>> 
>> Finally, modify the default configs from CONFIG_IPV6=m to CONFIG_IPV6=y
>> except for m68k as according to the bloat-o-meter the image is
>> increasing by 330KB~ and that isn't acceptable. Instead, disable IPv6 on
>> this architecture by default. This is aligned with m68k RAM requirements
>> and recommendations [1].
>> 
>> [1] http://www.linux-m68k.org/faq/ram.html
>> 
>> Signed-off-by: Fernando Fernandez Mancera <fmancera at suse.de>
>> Tested-by: Ricardo B. Marlière <rbm at suse.com>
>
> That's a Kconfig/defconfig only patch, so build system. You cannot test
> it in a meaning of testing code. Building code is not testing.

Should I have sent 9 emails instead of 1 to the whole series?

>
>> Acked-by: Krzysztof Kozlowski <krzk at kernel.org>
>
> You removed important parts of Ack. It was not provided like that.
>
> Best regards,
> Krzysztof