[PATCH 3/3] Only use the MULTIPATH attribute when adding routes with more than one next hop.

[Thomas Graf]

On Sun, Oct 09, 2011 at 05:02:36PM -0400, Michael Altizer wrote:
> Only use the MULTIPATH attribute when adding routes with more than one
> next hop.
> This solves issues with two scenarios:
> 1. Adding an IPv4 route to a kernel configured without
> CONFIG_IP_ROUTE_MULTIPATH=y.
> 2. Adding an IPv6 route in general, since the MULTIPATH attribute is not
> supported there.
> 
> Signed-off-by: Michael Altizer <xiche at verizon.net>

Applied, thanks Michael.