Libertas with if_spi on pxa270

[Mike Rapoport]

Andrey Yurovsky wrote:
> On Wed, Jan 28, 2009 at 1:54 AM, Mike Rapoport <mike at compulab.co.il> wrote:
> 
> Very strange.  I tried both Marvell's 'p37 firmware and the firmware
> from the linux-firmware tree and had identical results on the Blackfin
> boards.  Are you sure that the only thing that you changed is the
> firmware image set?  That is, both the helper and main firmware files
> (but named as libertas_spi expects them, shown above)?  I'm not aware
> of any serious differences in the two firmware versions.

It was my fault. Apparently downloading firmware blob from gitweb screwed the
things up. After I cloned the entire linux-firmware tree everything was Ok.

>>>> Can you actually use eth0 after the libertas_spi is loaded?
>>>>
>>> 'ifconfig eth0 up' works, 'iwlist eth0 scan' does not work. I get many more
>>> messages like the ones quoted above and after quite a while the scan fails.
>>> I've not tried to assoicate to an AP yet.
> 

-- 
Sincerely yours,
Mike.