[LEDE-DEV] [PATCH] ipq806x: Add nand boot support for ipq40xx AP-DK04.1-C1

[Ram Chandra Jangir]

>Hi Christian,

>Hello,

On Monday, May 08, 2017 10:24 PM Ram Chandra Jangir wrote:
> On Saturday, May 06, 2017 11:24 PM  Christian Lamparter wrote:
>On Friday, May 5, 2017 9:19:36 PM CEST Ram Chandra Jangir wrote:
> This change add nand boot support for IPQ40xx based
> AP-DK04.1-C1 board using ubi image, also add sysupgrage support for
> AP-DK04.1-C1 and generates a sysupgrade.tar image.
> 
> Testing:
> *Tested on IPQ40xx AP-DK04.1-C1 and IPQ806x AP148 Board:
>   a. NAND boot
>   b. ubi sysupgrade
> 
> Signed-off-by: Ram Chandra Jangir <rjangir at codeaurora.org>

>Thanks for posting this.

>Chris Blake is currently in the process of adding the Cisco Meraki MR33.
><https://github.com/riptidewave93/LEDE-MR33>
>The MR33 uses the IPQ4029 and has just a Spansion S34ML01G200TFV00 
>128MiB
NAND Flash for storage.

>He reported that with this patch attached. The driver is loading, but 
>it
can't access the nand: 

>[    0.860703] nand: second ID read did not match 7f,7f against 01,71
>[    0.861633] nand: No NAND device found

>The id is supposed to be 01 (manuf = Spanion), f1 (128MiB).
>both readings are bad.

>I think this is caused by two problems:

>1. 7f, 7f should be 0xff, 0xff. 0x71 should be 0xf1.

>2. It seems that the NAND chip was not ready on the first read. 

>I strongly suspect (due to the MSB error for BIT 7), that at least one 
>I/O
line is missing due to a bad pinctrl/mux setup.

>Could you please add the pinctrl nand definitions to the dts so he can 
>test
again?

>Regards,
>Christian

>IPQ4019 (ex. AP-DK04.1-C1) boards will  have nand boot mode with a
dedicated jumper settings.  Based on nand boot jumper settings change, HW
will automatically take care of initializing  the nand_pins mux at boot
time.
>That is why  we don't need to do initialization of  pinmux in ipq4019
kernel
>boot/dts.   Currently I don't have Cisco Meraki MR33 board with me to give
a
>try.
>I  will give a try for nor-nand  boot on ipq4019 with pinmux initialization
and will update you, if it helps you.

>Thanks,
>Ram

I added nand pinmux in https://patchwork.ozlabs.org/patch/761243/  , Could
you please try with this, if it helps you.
Old patch(has pinctrl definitions):
https://patchwork.ozlabs.org/patch/752962/ 

Thanks,
Ram



_______________________________________________
Lede-dev mailing list
Lede-dev at lists.infradead.org
http://lists.infradead.org/mailman/listinfo/lede-dev