[LEDE-DEV] ATH10K-CT debug messages

[Ben Greear]

On 06/04/2017 03:40 AM, Kevin Darbyshire-Bryant wrote:
> FAO that nice Mr Greer,
>
>
> I'm getting (for free) a nice selection of ath10 debug messages when using the Ath10K-ct firmware & driver in LEDE. A small collection reproduced below. Are
> they of any interest/use?

If you want to disable this, set the debug-mask bit 0x10000000 to 1.


[root at ben-ota-1 ~]# cat /debug/ieee80211/wiphy0/ath10k/debug_level
Current debug level: 0xc0000030

To change debug level, set value adding up desired flags:
PCI:                0x1
WMI:                0x2
HTC:                0x4
HTT:                0x8
MAC:               0x10
BOOT:              0x20
PCI-DUMP:          0x40
HTT-DUMP:          0x80
MGMT:             0x100
DATA:             0x200
BMI:              0x400
REGULATORY:       0x800
TESTMODE:        0x1000
WMI-PRINT:       0x2000
PCI-PS:          0x4000
AHB:             0x8000
NO-FW-DBGLOG:0x10000000
MAC2:        0x20000000
INFO-AS-DBG: 0x40000000
FW:          0x80000000
ALL:         0xFFFFFFFF


Thanks,
Ben

-- 
Ben Greear <greearb at candelatech.com>
Candela Technologies Inc  http://www.candelatech.com